Glossary · Smart money & ICT

Rejection block in gold trading

A rejection block is the zone made by the long wicks at a swing high or low, where price was pushed away hard; traders watch it for a reaction on the return.

Also called Wick rejection block, ICT rejection block

A rejection block is an ICT (Inner Circle Trader) term for the price zone covered by the long wicks at a swing high or swing low. The long wick shows that price went there, met strong orders and was pushed away. The block runs from the extreme of the wick to the body of the candle (usually the highest or lowest candle close near that swing). When price comes back to that zone, some traders expect it to be rejected again.

How it applies to gold trading

Gold makes long wicks often, especially around US data and the London and New York opens, so rejection blocks appear on most time frames. They work best at a level that already matters, such as the previous day’s high, a round number like 4,000, or the edge of a range. A wick in the middle of nowhere is just noise. Many traders wait for price to sweep the wick’s extreme, then turn back inside the block, before acting.

Worked example

Example (hypothetical numbers): gold rallies to 4,068 during the New York open, then falls back to close the 1-hour candle at 4,052. Nearby candles also closed around 4,052, so the rejection block is 4,052 to 4,068. Two days later price returns to 4,058 and stalls. A trader sells at 4,056 with a stop at 4,071, just above the wick, and a target at 4,026. Risk is $15 per ounce, the target is $30, a 1:2 risk-reward. On 0.10 lots (10 ounces) the risk is $150. If price closes above 4,068, the block has failed.

A common mistake

Marking every wick as a block. Only use wicks at a clear swing high or low and at a level that matters on a higher time frame, and always place the stop beyond the wick, not inside it.

Mentioned in these glossary entries: ICT, Propulsion block.

See also: Wick, Order block, Liquidity sweep, Pin bar, Swing high and swing low.

Frequently asked questions

What is an ICT rejection block?

It is the zone between the extreme of the long wicks at a swing high or low and the nearby candle bodies. ICT traders expect price to react there again when it returns.

How is a rejection block different from an order block?

An order block is the last opposite-colored candle before a strong move, measured by its body. A rejection block is drawn from the wicks at the swing point itself.

Where do I put the stop on a rejection block trade?

Just beyond the extreme of the wick, plus a small buffer for the spread. If price closes past the wick, the idea is wrong.